UPSZTEC For Mercedes Benz V Class 260 260L 2016-2020 Car Tail Light Reversing Rear Lamp Shade Brake Indicator Cover

Features:
-Easy to install and fits well.         
-Anti-scratch edge will not hurt your hands.
-Durable, scratch-resistant, dirt-resistant and anti-corrosion
-Correct Connector No cutting or splicing.
-It is a cover only.
-Strict quality control standards to Build and test.          

Attention:
-Please kindly check the item description and photos to make sure it suitable for your car before ordering.
-Due to light and screen difference, the item's color may be slightly different from the pictures.
-Please allow 1-2mm Length error due to manual measurement. 


Installation Step:
1.If you have an oven, that would be the best. Just remove the back cover and bulb of the lamp, then put it in the oven and heat it to 80 degrees for 10 minutes. The glue will soften and the lampshade and the shell will be easier to separate.   
2.If you don't have an oven, you have to use a heat gun. First, heat the sharpest corner of the headlight with the heat gun, heat it section by section, and insert a flat-bladed screwdriver after it softens. Be careful not to use too much force to avoid damage. Stop when it is a little hot to the touch with gloves! (Note: The temperature cannot be too high to avoid damaging the headlight).
3.After the heating is finished, quickly and forcefully pull that corner apart. Pull it apart with all your strength~~ (Be sure to wear gloves when pulling it apart. The gloves must not shed hair, and avoid using too much force).
4.Everything went smoothly and I was quite skilled. One minute was enough from heating to peeling them apart. If it didn't go smoothly, I would continue to heat the separated area with a hot air gun to soften the glue, and it would be easy to peel them apart by applying force with my hands.
5.Clean as much glue as possible from the glue groove on the back shell, put on gloves, then remove the decorative frame from the lampshade and install it on the new lampshade.
6.Put the glue we provide on the pointed lid, cut the lid with scissors (don't cut it too big, just cut it into an inclined surface) and pour glue into the groove (if the glue flow is too small, you can cut it larger), make sure that the glue reaches half to two-thirds of the height of the glue groove (do not disconnect the glue when applying, and keep the height as consistent as possible).
7.Press the new lampshade onto the back shell. If you find some glue overflowing, you can ignore it for now. After the glue is dry, you can cut it off with a blade. There is glue on the surface of the lampshade, which can be wiped off with a cloth.
8.You may go to professional automotive shop for install.
    
Note: We recommend that you let it air dry in a ventilated environment for three to five days before loading it on the vehicle. Do not wash the car or expose it to rain within a week to prevent water from penetrating into it.

Product RFQ:

Q:How do i know if this product can fit my car or not.
A:If you are not sure,you can send the original dashboard photo to us for checking via email or customer service onlineQ: Where will you ship
A:We will ship put from shenzhen,china

Q:When can you ship out after paying
A:We usual will ship out within 3 to 5 work days

Q:What is the delivery time
A:It usual take 5 to 10 work days shipping by express,the delivery time are different deponds on the different country.

If you have any problem about the shipping,please feel free to contact with us via [email protected]